Firmware 1.6.2
Features & Improvements:
Updates
- Prepare ODM Option: DHCP as default
- Support and Power Management for 8CH
- EQ changes – aligning it on input output and speaker EQ
- Device name to be displayed in the tab of the browser
- Stereo linking improvement for zones
- Validate SSDP for all models from the specific vendors
- Create REST API endpoint for quering device
- Add validation before storing configuration
- Reset Amp – Keep Network Settings
- Decrease standby power consumption in standby mode
- Improve MDNS Naming
Bugfixes
- Misaligned faders and scales
- Input EQ filter type changes not registered by amp.
- Cancelling the FW update during update causes crash
- Undervoltage Detection and Protection on 7.5V Rail
- Amplifier disable do not mute the UA-module
- Threshold not showing the same amount of decimals consistently in the WebGui
- Writing more than 32 chars in “Installation notes”
- The configuration is reset after a reboot
- Connected Wall Controller displays update icon – when not paired
- 256 character string in notes is not restored to 256, instead 84
- Clip indication when no music played
- No bridgemode for Dante Amps
- Invalid Hardware “License” not indicated on LEDS
- Disable ethernet led in standby mode
- DSP hibernate mode when 1V2 is disabled.
- Firmware Upload using chunked upload crashed amplifier
- Amplifier doesn’t enter standby via GPIO when in “Network mode”
- Ethernet LED not updated in standby mode
- GPIO Default settings not correctly labeled in UI
- Unable to set Standby timeout time in “Audio (DSP)”
- Slider not visible
- Connection handling – evaluation buildup