Release Notes - Wall-S1 | Blaze Audio

Home / Support / Release Notes – Wall-S1

Firmware: Blaze Audio Wall-S1 controller

Introducing the latest firmware update for the Blaze Audio Wall-S1 controller.

With this update, you can expect to experience upgraded functionality and take advantage of all the new improvements
and enhanced features of your Blaze Audio Wall-S1 controller.

Please note that Blaze Audio Wall-S1 controllers are only compatible with Blaze Audio PowerZone Connect™ amplifiers running firmware version 1.3.0 or later.

To avoid any installation and configuration issues, we recommend updating the firmware installed on your Blaze Audio PowerZone Connect™ amplifier before attempting to install and configure the Blaze Audio Wall-S1 controller

Thank you for choosing Blaze Audio.

March 25, 2024

Firmware 1.2.2

Features & Improvements:

Bugfixes

Minor fixes

January 29, 2024

Firmware 1.2.1

Features & Improvements:

Features

Review MDNS properties
Check SWID before SW update
Code Cleanup
Update Build System – for support Multiple SWID’s
Support custom boot splash
Rewrite WebSocket Client handling to Mongoose
Enable AutoIP – Link Local IP addressing
Make MDNS instance name the same as Given name in setup
Improve stability of callbacks
Handle Amp – MDNS updates
Optimize Encoder Inputs

Bugfixes

Encoder overrun
Device reboot when trying to change ip settings (address)
Using Zyxel switch causes unexpected reboot on Wall-S1
Abort FW update might cause crash
Exception in freertos queue.c cases reboot.
Draw buffer sometimes NULL
Update from webpage not working
Reboot from webpage not working
Volume returns to 1 when turning knob counter clock wise
after mute

April 12, 2023

Firmware 1.1.0

Features & Improvements:

Features

Select Mix from the Blaze Audio Wall-S1 controller
Disable Mute (KraftWerk API)
Disable Sources
When connecting, use standard brightness settings
Replace WebServer with Mongoose
User should be able to locate specific Blaze Audio Wall-S1 controllers
Separate pin code for volume/src

Updates

Update to ESP IDF 4.3.4
Unable to find sources in FW 1.3.x

Bugfixes

Cannot connect to amplifier if Amp-IP has changed
After “Reset to factory” IP, GATE, and mask are set to 255.255.255.255